|
|
International Journal of Automotive Technology 2008;9(4): 405-413. |
| COMPARISON OF HC SPECIES FROM DIESEL COMBUSTION MODES AND CHARACTERIZATION OF A HEAT-UP DOC FORMULATION |
| M. HAN, D. N. ASSANIS, S. V. BOHAC |
| University of Michigan |
|
|
|
|
|
| ABSTRACT |
|
This study summarizes engine speed and load effects on HC species emissions from premixed charge compression ignition (PCI) and conventional diesel combustion, and it evaluates diesel oxidation catalyst (DOC) formulations on a gas flow reactor for the purpose of diesel particulate filter regeneration or lean NOx trap desulfation. HC emissions are sampled simultaneously by a Tedlar bag for light HC species and by a Tenax TATM dsorption trap for semi-volatile HC species, and they are analyzed by gas chromatography with a flame ionization detector. The bulk temperature and residence time during combustion are key parameters that are important for understanding the effects of speed and load on engine-out HC emissions. The degree of post-flame oxidation is higher in PCI than in conventional combustion, and it is increased for PCI with a higher speed and load, as indicated by a lower fuel alkanes/THC ratio, a higher alkenes/fuel alkanes ratio, and a higher methane/THC ratio. Ethene and n-undecane are two representative HC species, and they are used as a surrogate mixture in the gas flow reactor to simulate PCI and conventional combustion with in-cylinder post fuel injection. Among the three DOC formulations tested, the catalyst with constituent precious metals of platinum and palladium (PtPd) showed the best light-off performance, followed by PtPd with an addition of cerium dioxide (PtPd+CeO2), and platinum (Pt), regardless of exhaust compositions. Conventional combustion exhaust composition shows a lower light-off temperature than that of PCI, regardless of catalyst formulation. |
| Key Words:
Diesel oxidation catalyst (DOC), Gas flow reactor, Premixed charge compression ignition (PCI) |
|
|
|
Preview
Full text via DOI 
Download Citation 
Print 
