Int J Automot Technol Search

CLOSE


International Journal of Automotive Technology > Volume 14(5); 2013 > Article
International Journal of Automotive Technology 2013;14(5): 817-827.
doi: https://doi.org/10.1007/s12239-013-0090-3
METHODOLOGY FOR THE ACCURACY IMPROVEMENT OF FEM BEAM TYPE T-JUNCTIONS OF BUSES AND COACHES STRUCTURES
E. ALCALÁ, F. BADEA, Á. MARTIN, F. APARICIO
University Institute of Automobile Research of the Madrid Community
ABSTRACT
The analysis of structures with finite elements methods (FEM) represents a widely spread technique. For large tubular structures similar to the buses and coaches upper structures, beam type elements are utilized due to the fact that these elements provide satisfactory results at relatively reduced computational performances. However the beam type elements have a main disadvantage determined by the fact that the modeled joints have an infinite rigid behavior. This shortcoming determines a stiffer behavior of the modeled structures which translates into an error source for the structural simulations (up to 45%). To overcome this problem, a simple methodology was conceived and an alternative optimized equivalent beam model obtained. The methodology studies the behavioral characteristics of beam modeled T-junctions determining their limitations and comparing them to equivalent T-junctions modeled with shell and volume elements. This way an improved Tjunction has been obtained, in which the behavioral error was reduced to less than 5%. Furthermore the FEM obtained results were validated with real T-junctions.
Key Words: Structural optimization, Bus structural analysis, FEM (Finite Elements Methods)

Editorial Office
21 Teheran-ro 52-gil, Gangnam-gu, Seoul 06212, Korea
TEL: +82-2-564-3971   FAX: +82-2-564-3973   E-mail: manage@ksae.org
About |  Browse Articles |  Current Issue |  For Authors and Reviewers
Copyright © The Korean Society of Automotive Engineers.                 Developed in M2PI
Close layer
prev next