| CLAMPING PERFORMANCE OF FASTENER IN WINDSHIELD WIPER ASSEMBLY USING THEORETICAL AND EXPERIMENTAL METHODS |
| J. H. CHUNG1, K. H. LEE2, C.-H. LEE2, N. K. KONG3 |
1INHA Univ. AVDC Lab.
2Inha University
3Hyundai motor company |
|
|
|
|
|
| ABSTRACT |
|
Improper clamping of wiper arms can cause problems in the operation of the wiper. An excessive clamping force can cause damage to the wiper arm head. On the other hand, an insufficient clamping force can cause self-loosening of the nut. Given the lack of direct research on the clamping force of the fastener in wiper assembly, this study verifies the existing clamping performance of the fastener in windshield wiper assembly by theoretical and experimental methods. The theoretical calculation results show that all the clamping performance are satisfied under the general snow load condition. However, under the critical load condition, maximum assembly preload and safety margin against slipping are in disagreement with the standard values. This problem is solved by increasing the strength grade of the bolt. The experimental results show a reducing tendency of the clamping force during the snow durability test. However, this reducing clamping force during the 60,000 test cycles is acceptable. In the case of nut reusing more than two times possibly cause a problem of its loosening because of insufficient clamping force. Therefore, it is recommended that the nut should not be reused more than two times. |
| Key Words:
Fastener, Clamping performance, Measurement system, Self-loosening |
|
|
|
Preview
Full text via DOI
Download Citation 
Print 
