EFFECT OF INTAKE PORT GEOMETRY ON THE IN-CYLINDER FLOW CHARACTERISTICS IN A HIGH SPEED D.I. DIESEL ENGINE

LEE, K. H.; RYU, J. D.; LEE, C. S.; REITZ, R. D.

International Journal of Automotive Technology > Volume 6(1); 2005 > Article

Engine, Emission Technology

International Journal of Automotive Technology 2005;6(1): 1-8.

EFFECT OF INTAKE PORT GEOMETRY ON THE IN-CYLINDER FLOW CHARACTERISTICS IN A HIGH SPEED D.I. DIESEL ENGINE

K. H. LEE¹, J. D. RYU¹, C. S. LEE¹, R. D. REITZ²

¹Hanyang University
²University of Wisconsin-Madison

ABSTRACT

Recently, the HSDI (High Speed Direct Injection) diesel engine has been spotlighted as a next generation engine because it has a good potential for high thermal efficiency and fuel economy. This study was carried out to investigate the in-cylinder flow characteristics generated in a HSDI diesel engine with a 4-valve type cylinder head. The four kinds of cylinder head were manufactured to elucidate the effect of intake port geometry on the in-cylinder flow characteristics. The steady flow characteristics such as coefficient of flow rate (Cf), swirl ratio (Rs), and mass flow rate(ms) were measured by the steady flow test rig and the unsteady flow velocity within a cylinder was measured by PIV. In addition, the in-cylinder flow patterns were visualized by the visualization experiment and these results were compared with simulation results calculated by the commercial CFD code. The steady flow test results indicated that the mass flow rate of the cylinder head with a short distance between the two intake ports is 13% more than that of the other head. However, the non-dimensional swirl ratio is decreased by approximately 15%. As a result of in-cylinder flow characteristics obtained by PIV and CFD calculation, we found that the swirl center was eccentric from the cylinder center and the position of swirl center was changed with crank angle. As the piston moves to near the TDC, the swirl center corresponded to the cylinder center and the velocity distribution became uniform. In addition, the results of the calculation are in good agreement with the experimental results.

Key Words: Helical intake port, ISM (impulse swirl meter), Swirl ratio, Intake flow rate, PIV (particle image velocimetry), HSDI (high speed direct injection)

TOOLS