| DEVELOPMENT OF ENGINE CONTROL USING THE IN-CYLINDER PRESSURE SIGNAL IN A HIGH SPEED DIRECT INJECTION DIESEL ENGINE |
| S. YU1, H. CHOI2, S. CHO3, K. HAN3, K. MIN1 |
1Seoul National University
2AICT
3Hyundai Motor Company |
|
|
|
|
|
| ABSTRACT |
|
Emission regulations are becoming more stringent and remain a principal issue for vehicle manufacturers. Many engine subsystems and control technologies have been introduced to meet the demands of these regulations. For diesel engines, combustion control is one of the most effective approaches for reducing not only engine exhaust emissions but also cylinder-by-cylinder variation. However, the high cost of pressure sensors and the complex engine head design for additional equipment present difficulties for manufacturers. In this paper, cylinder pressure-based engine control logic is introduced for a multi-cylinder high speed direct injection (HSDI) diesel engine. The time for 50% of the mass fraction to be burned (MFB50) and the IMEP are valuable for determining the combustion status. These two in-cylinder quantities are measured and applied to the engine control logic. Fuel injection timing is controlled to adjust the operating MFB50 to the target MFB50 using PID control logic, and the fuel injection quantity is controlled to adjust the measured IMEP to the desired IMEP. The control logic is demonstrated at steady state and during transient conditions and is applied to an NEDC mode test. |
| Key Words:
Combustion control, Diesel engine, NEDC mode, Real-time, MFB50, IMEP |
|
|
|
Preview
Full text via DOI
Download Citation 
Print 
